The International Cessna 170 Association

Turns out the wrong parts were installed in the outboard portion of the wheel. The grease seal felt is half the width of the inboard side and is covered with a metal cup on the 40-97a assy...Cleveland sent me the assy diagram that shows the inside washer is held to the cone by the nut and the seal r...

Is there a spacer between the axle nut and the bearing cone? The nut seems to be installed against the grease seal discs. Cleveland does not show a spacer in the IPC. I think the pants are installed incorrectly....The seals should rotate around the nut and cone....no part number available...thanks ron

Check out Waldo's at KHII (Lake Havasu) BBQ good food,great service. 928-764-3663 Cheap gas next door.......ron 8873

Still unable to get the member number, was not on the email...

Wasn't aware I violated any rules, I did pay the dues, apparently didn't catch up. thanks for the welcome...ron

Restoring a rag 170, need a LH tank with the cover flange attached or the flange assy from damaged tank hopefully with the cap assy attached. ...thanks ron