Search found 21 matches

by LEA
Mon Mar 27, 2006 2:00 am
Forum: The Hangar
Topic: Help in finding source of fuel leak
Replies: 3
Views: 3156

Curt; You failed to mention if the stain appears after the plane has set for a time after you have cleaned off the stain.Or does the stain appear after a flight? Check the plumbing at your fuel pump (front of # 5 Cylinder) ,also check the fuel line from the fuel strainer line to the carb.It may be a...
by LEA
Sat Mar 25, 2006 2:55 am
Forum: The Hangar
Topic: Aftermarket combustion heater possibly available
Replies: 17
Views: 18230

Gentlemen ; All cessna 190 & 195 Aircraft were all equiped with Stewart Warner gasoline heaters. If there is one of these aircraft located near you a visual inspection will reveal the location and necessary modification to the fuselage deck to provide adaquate clearance for the rear seat. It wou...
by LEA
Thu Mar 23, 2006 3:20 am
Forum: The Pilot Lounge
Topic: What is the lowest time 170B model that is currently flying?
Replies: 22
Views: 15973

I am not an authority on the subjects of cracking skins ,however,I know the adaptation of floats to any aircraft will place excessive strain on the structure and skins of support. The only recorded time of structural failure of Cessna 195 aircraft in flight was two seperate cases where the aircraft ...
by LEA
Tue Feb 21, 2006 10:04 pm
Forum: The Hangar
Topic: Looking for some "simple" answers
Replies: 12
Views: 16281

Paul--I looked through my old files and lo & behold , I have a Micrologic ML-6500 Pilots guide. I will gladly send it to you ,no charge ,if you will provide me your mailing address.

Robert Lea TIC170A member
Amarillo ,Texas E-Mail (boblea5 (at) excite.com)
by LEA
Mon Oct 10, 2005 10:08 pm
Forum: The Pilot Lounge
Topic: ADIZ areas
Replies: 3
Views: 3829

Good man Craig; I also sent in a response to Docket 17005 ,I request all our members to write or E-Mail your objections to this proposed ruling.Next thing you know Mayor Daily of Chicago will ask the FAA to place an ADIZ over Chicago. So---my fellow members get off your duff and communicate your fee...
by LEA
Mon May 02, 2005 12:33 am
Forum: The Hangar
Topic: REPLACEMENT AXLES
Replies: 4
Views: 4766

REPLACEMENT AXLES

I have not acquired any confirmation from members as to what are approved replacement axels for the rag winged C170?Has anyone any
information & source for the solid or hollow steel axels approved for the 1948 C170?

BOB #7693
Amarillo,Tx.


C195B Destroyer![/url]