Where’s the current ‘go to’ place for seat rails? Still McFarlane? Annual planning underway and that may be on the list this year.
(Or maybe someone has a couple sets they need to get rid of?)
Seat Rail Replacement
Moderators: GAHorn, Karl Towle, Bruce Fenstermacher
- Kyle Wolfe
- Posts: 707
- Joined: Mon Mar 17, 2003 12:30 am
Re: Seat Rail Replacement
Kyle
54 B N1932C
57 BMW Isetta
Best original 170B - Dearborn, MI 2005
54 B N1932C
57 BMW Isetta
Best original 170B - Dearborn, MI 2005
Re: Seat Rail Replacement
Has anyone used the approved screws to attach the seat rails rather than rivets as advertised at McFarlane Aviation when replacing seat rails?
Re: Seat Rail Replacement
The McFarlane seat rails are slightly “beefier” than OEM. https://www.mcfarlaneaviation.com/produ ... ails/faqs/
The website has some illustrations as well as a link to the Special Airworthiness Information Bulletin CE-90-03R2 https://www.mcfarlaneaviation.com/media ... 0-03r2.pdf permitting screws instead of rivets.
The website has some illustrations as well as a link to the Special Airworthiness Information Bulletin CE-90-03R2 https://www.mcfarlaneaviation.com/media ... 0-03r2.pdf permitting screws instead of rivets.
'53 B-model N146YS SN:25713
50th Anniversary of Flight Model. Winner-Best Original 170B, 100th Anniversary of Flight Convention.
An originality nut (mostly) for the right reasons.
50th Anniversary of Flight Model. Winner-Best Original 170B, 100th Anniversary of Flight Convention.
An originality nut (mostly) for the right reasons.
Re: Seat Rail Replacement
I have used screws for the larger diameter fasteners at the ends of the rails. You just have to spot-face the locations on the rail to make sure the screw heads have a square seat. This picture shows the old rail I used for practice and the new rail freshly spot-faced.jcsand wrote:Has anyone used the approved screws to attach the seat rails rather than rivets as advertised at McFarlane Aviation when replacing seat rails?
Re: Seat Rail Replacement
The only place I have ever installed screws is at the ends where they tie into the bulkheads, when the rivet holes were questionable. I have seen them installed with screws and thought it looked cheap. If you can reach in and install a nut and washer, why not just buck a rivet? Since it requires a structural screw, it seems you would have to upsize all your holes to accommodate a #8 screw.
McFarlane rails may be beefier, but they don't seem to have the strength of the originals. I once demonstrated this by taking a misdrilled one and bending it around my knee.
McFarlane rails may be beefier, but they don't seem to have the strength of the originals. I once demonstrated this by taking a misdrilled one and bending it around my knee.
Re: Seat Rail Replacement
Thanks for your time/thoughts regarding screws vs. rivets in the seat rails. I think that I'll go with rivets.
Re: Seat Rail Replacement
I wonder if the older seat rails have work hardened over time?cessnut wrote:The only place I have ever installed screws is at the ends where they tie into the bulkheads, when the rivet holes were questionable. I have seen them installed with screws and thought it looked cheap. If you can reach in and install a nut and washer, why not just buck a rivet? Since it requires a structural screw, it seems you would have to upsize all your holes to accommodate a #8 screw.
McFarlane rails may be beefier, but they don't seem to have the strength of the originals. I once demonstrated this by taking a misdrilled one and bending it around my knee.