What did you buy for your 170 today?

[dkmp215]

Dave what a clean looking airplane, the larger spinner just looks right on your plane.

Yes John, I consider myself to be very lucky. The airplane was put into its current condition by its previous owner, a local AME and vintage airplane lover, who continues to perform its maintenance. The 'look' of the current spinner took me awhile to get used to -- I liked the old skull cap look -- but this new one came as part of an O-300-D installation that was in place 2 years before I purchased the airplane. After a few months, however, the new look started to look 'just right'.
Have a great summer.

[nippaero]

Six pack of cylinders for my overhaul this fall.

[fishdoc]

After a long unsuccessful attempt at converting my 170A and hoping for some follow through from DelAir for the STC and installation kit - which may Never occur - I bought all the parts and pieces for a beautiful converted 170B with all the bells and whistles - fully assembled and ready for action!!
Should have just done this all along like everyone suggested.....

[nippaero]

Two big boxes showed up for 80A. Complete new interior kit from Airtex.

[nippaero]

After spending quite a bit of time looking for one of these, I finally found one. Now my door latch will be happy.

[nippaero]

Lol. I think that guy has more of them.

[swixtt]

That is one heck of a new 170b fishdoc. My favourite one now !!

[GAHorn]

... With all of the fuel system with the new IO 360 having the header tank inside the airplane. I thought a fire extinguisher would be a good Idea. A good ide in any case and something I have been meaning to do anyway. I will purchase a hose for the fire extinguisher that Amerex sells seperatly.

C352TS halon RS.jpg

....
Jim

Smart! VERY! Good on ya'!

[nippaero]

New PMA8000BTi audio panel and two new radios. Just finishing up the wiring harness. I plan on installing it while I have the interior out so I can run all the wire and rear headset jacks.

[nippaero]

Had some nice stuff from BAS show up this week. Shoulder harnesses and tail pull handle.

[Kyle Wolfe]

IMG_1699.JPG (31.03 KiB) Viewed 26191 times

Rosens, repainted gear legs and repainted steps. Trying to make her a little better each year.

[VernH]

Concorde RG-25XC and Hooker Harness!!

[DaveF]

Eight new UREM-38S fine-wire spark plugs.

[rydfly]

A new Garmin 335GTX ADS-B OUT transponder. Also removed the old ADF antenna to install the required GPS antenna in its place.

[brian.olson]

My A&P just ordered a brand-spanking new (complete) set of Airform baffles and a new tailwheel spring assembly. All proactive to keep out of trouble. Install date mid-January.

Edit (1/19/2018): just received some progress photos from the A&P doing the install work. Note "before" and "after" ...