Page 1 of 1
Fuse holder
Posted: Tue Sep 22, 2015 5:28 pm
by OTIS
I had one of my fuse holders break and need a replacement. The part # is 0411023-1 (Retainer - Fuse)
Does anyone have an extra they want to sell or now where I can buy one?
Gerry Whitson
N8072A
Re: Fuse holder
Posted: Tue Sep 22, 2015 7:15 pm
by blueldr
I have two fuse holders sitting here on my desk i front of me. One for a 5/16" dia, fuse the other for a 1/4" dia.
Send me a couple of bucks for postage and they're yours.
Dick Lemmon
2469 Knightwood Way
Rancho Cordova, CA 95670-5104
Ph. (916) 635-5566
Re: Fuse holder
Posted: Thu Sep 24, 2015 11:41 am
by OTIS
Thank you Dick. I'll mail you a $10 check today.
Gerry Whitson
311 Meadow Lake Drive
Taylorsville, KY. 40071
Re: Fuse holder
Posted: Thu Sep 24, 2015 3:48 pm
by blueldr
Gerry,
Thanks for the offer but I don;t want to sell the fuseholders. I'm just going to loan them to tou on a permanent basis. All I want is postage, thank you.
D ick
Re: Fuse holder
Posted: Sun Oct 04, 2015 3:32 am
by OTIS
Thanks again. Did you receive an envelope from me last week?
Gerry
Re: Fuse holder
Posted: Sun Oct 04, 2015 6:54 pm
by blueldr
Gerry,
I've received nothing at all so far.
Dick
Re: Fuse holder
Posted: Thu Oct 08, 2015 1:41 pm
by OTIS
Dick, I mailed the postage check yesterday. Gerry
Re: Fuse holder
Posted: Thu Oct 08, 2015 4:12 pm
by blueldr
I'll be watching the mail for it. Thanks.
Re: Fuse holder
Posted: Sat Oct 10, 2015 2:45 am
by GAHorn
Been drinkin' that Kain-tucky Hooch agin' , Gerry...??? (an' fergot to mail the chek?)
Re: Fuse holder - second try
Posted: Sat Nov 07, 2015 8:24 pm
by OTIS
George........yes on local hooch.
I'm still looking for a fuse cap. Dick sent me a complete fuse assembly. Unfortunately, it uses a different type cap. A
I took a picture, but it is to large to upload. My fuse cap is 1 1/8 inches long and screws into the fuse holder. Not sure
Where to go from here.
Gerry
N8072A
Re: Fuse holder
Posted: Sat Nov 07, 2015 10:44 pm
by n3833v
Gerry,
I think I have what you need. The screw part is 1.25 in long with the knerl knob is .5 in with fuse printed on the end for a .25 fuse.
John
Re: Fuse holder
Posted: Mon Nov 16, 2015 8:46 pm
by OTIS
John, I received your package today. It was the correct part. Thank you very much. Gerry
Re: Fuse holder
Posted: Tue Nov 17, 2015 12:34 pm
by n3833v
You are welcome. Now I hope you fly safely with the extra unit working. This was from when I changed my panel to all breakers for my IFR panel.
John