Page 1 of 1
Federal AWB 2500 Rigging
Posted: Mon Dec 21, 2020 2:41 pm
by SethR
Looking for rigging instructions for AWB2500 retractable wheel skis. Any leads appreciated.
Re: Federal AWB 2500 Rigging
Posted: Mon Dec 21, 2020 3:16 pm
by hilltop170
Not really sure what you are asking, a more specific question would help.
There is a supplement/attachment to 43-13 that specifically deals with rigging skis.
You didn't say what airplane you intend to install them on but if it's a 170 and you have all the L-19 attachment hardware, there isn't really any rigging to do. The rigging is mostly done once the attachment hardware is in place.
There are different types of springs or bungees that can be used, your choice.
I have installed AWB2500 skis but really don't know what Info you are looking for.
Re: Federal AWB 2500 Rigging
Posted: Mon Dec 21, 2020 9:44 pm
by SethR
This is for a 170B. I have all hardware but I was under the impression there was a document as to specific up/down angles the cables would limit the skis along with specific recommended attachment locations. Tow in/out position, etc. something specific to the awb2500's.
Re: Federal AWB 2500 Rigging
Posted: Tue Dec 22, 2020 2:59 pm
by mitchw4
Most of that info is here I believe, 3rd post from the bottom of page 2 ---->
viewtopic.php?f=31&t=9329&start=15
Re: Federal AWB 2500 Rigging
Posted: Wed Dec 23, 2020 8:16 pm
by SethR
Mitch,
I'm unable to view the link-
Re: Federal AWB 2500 Rigging
Posted: Thu Dec 24, 2020 3:36 pm
by mitchw4
SethR wrote:Mitch,
I'm unable to view the link-
I think you need full member access to view that section of the forum.
Re: Federal AWB 2500 Rigging
Posted: Sun Dec 27, 2020 1:33 am
by GAHorn
mitchw4 wrote:SethR wrote:Mitch,
I'm unable to view the link-
I think you need full member access to view that section of the forum.
He is a full Member. Seth, try it again and if you have diffuculty contadt me via PM.