Table of Limits in Overhaul Manual
Posted: Wed Dec 01, 2021 6:55 pm
In the O-300 overhaul manual table of limits some of the joints have values followed by an "L" or "T". Can anyone tell me the meaning of those? I've looked all through the manual with no luck.
I assume that "L" would be for a loose fit (meaning there should be clearance) and "T" is for a tight fit (meaning it is a press fit). I just hate assuming, though.
Thanks,
Doug
I assume that "L" would be for a loose fit (meaning there should be clearance) and "T" is for a tight fit (meaning it is a press fit). I just hate assuming, though.
Thanks,
Doug