The International Cessna 170 Association

Looking for drawings to install TC approved EDO 2000 floats on a 170B. TC makes reference to Drawing #0541125B. Anyone have these drawings that I could buy a copy of ?
Thanks,
Greg V

Greg,
drawing 0541125 (without the “B”) is in the Maintenance Library which requires membership to access.

Be aware that the oil “gauge rod” (dipstick) will be in error if a landplane is placed on floats. This thread discusses it: viewtopic.php?f=24&t=14167&p=133560&hil ... od#p133560

GAHorn wrote:Be aware that the oil “gauge rod” (dipstick) will be in error if a landplane is placed on floats. This thread discusses it: viewtopic.php?f=24&t=14167&p=133560&hil ... od#p133560

Was the same on my 180 when on floats. I etched a faint line for “normal” to pseudo calibrate.
Thanks for the reminder!
SQRHD

n2582d wrote:Greg,
drawing 0541125 (without the “B”) is in the Maintenance Library which requires membership to access.

According to the TC (Note: 209), drwg# 0541125B is required for 170B’s (weight & balance wise). And I am a member, so I can access this, correct?

Thanks,
SQRHD

SQUAREHEAD wrote:

n2582d wrote:Greg,
drawing 0541125 (without the “B”) is in the Maintenance Library which requires membership to access.

According to the TC (Note: 209), drwg# 0541125B is required for 170B’s (weight & balance wise). And I am a member, so I can access this, correct?

Thanks,
SQRHD

We often find forum “participants” who believe by their participation in the free, Public areas of the Forums, that they are “Members” of the 170 Assoc’n.
But, Only bona fide, paid Members of The Int’l Cessna 170 Assoc’n may access the non-public areas of our Forums such as the Mx Library, Members Intercom, and post Ads in The TradeMart.
You may join at the Home Page. https://cessna170.org/register/