The International Cessna^® 170 Association

Anyone have any pictures for this part?
I looked up the part number in the parts manual and found it on iwantcessnaparts.com , but it's listed as applicable to the 182 and 210 and costs 180$. I'm thinking (hoping) that is the wrong part number.
I don't really know what I'm looking for so an installed pic would be helpful.

I can't really believe it would cost almost 200$ when the whole tailwheel spring assembly for both sides only cost 19$.

Thomas

These pictures provided by Plagiarist are us. Thanks Mark!

I saw that thread and wondered ... any chance of a closeup?

Where can I get that part ... ?

Thomas

Thomas, those parts are available from Air Repair, Inc. and have your 170 assn member number handy.
You may contact Air Repair either at:
> PH: 662-846-0228 or
> http://www.airrepairinc.com/

Thomas, those parts are available from Air Repair, Inc. and have your 170 assn member number handy.
You may contact Air Repair either at:
> PH: 662-846-0228 or
> http://www.airrepairinc.com/

(Tell Pete and/or Su I said hi.)

You should have their part numbers handy, as they are different than the 170 part numbers. Since you won't likely have their parts catalog, here's the part numbers:

Part: 0642108 shackle, 0642125 guard, AN4H21A bolt, MS2104/AN4 nut

I recommend slipping a short section of rubber hose/tubing over the shank of that bolt when you install it. It's not absolutely necessary, but many do it to keep the bolt from rubbing the spring.

George

tshort wrote:I can't really believe it would cost almost 200$ when the whole tailwheel spring assembly for both sides only cost 19$.

Thomas

Thomas, call Pete like George suggested. I did and got all the parts listed above shipped to AK in less than 4 days and for far less than a C-note! I was going to post a picture but I've got too much paint on my tail spring for the part to fit. I'll have to work on that.