Page 1 of 1
Oil Filler
Posted: Tue Jun 20, 2006 6:25 am
by mit
Ok
does any one have a way of tightening up the steel neck on the oil filler as it goes into the Assy case?
Posted: Tue Jun 20, 2006 6:34 am
by GAHorn
Isn't that swaged into the case similar to the pushrod tubes attachment to the cylinder head? I don't know where you're going to get that tool unless a rebuilder has one to loan or TCM can advise you.
Posted: Tue Jun 20, 2006 6:47 am
by mit
gahorn wrote:Isn't that swaged into the case similar to the pushrod tubes attachment to the cylinder head? I don't know where you're going to get that tool unless a rebuilder has one to loan or TCM can advise you.
Yep that it. I have been nursing it for years an it ain't getten any better
I haven't tried to hard to find out. I guess I will call around... I will let you know what I find out.