The International Cessna^® 170 Association

Hello all, I am looking for a copy of STC SA3-672 from KWAD company in alanta GA. Does anybody know if they are still in buisness? Or better yet does anybody know where i might get a copy of that STC? All i really want at this piont is to see what the STC says. Thanks, for any help you might be able to pass on. rod

This certificate issued to:
KWAD Company

STC Holder's Address:
4530 Jettridge Dr. N.W.
Atlanta GA 30327
United States

Description of the Type Design Change:
Lycoming O-360-A1A, A1D or B1B engine and McCauley2D36C14-X/78KM-4 propeller or Lycoming O-360-A1A and A1D engines with Hartzell HC-C2YK-1A/7666A-2 propeller.

Responsible Office:
ACE-115A Atlanta Aircraft Certification Office Tel: (770) 703-6035


http://www.airweb.faa.gov/Regulatory_an ... ht=sa3-672

Thanks , but I already have that information. What I was hoping for is that mabye someone had a copy of the STC or mabye had a phone number for KWAD company, if they are in buisness anymore? What i,m trying to find out if there are any limitations with that stc , such floats, or no floats allowed, any equiment that may have to be installed, etc. I like to see what the STC says. Can I get a copy of what the STC says from the FSDO?

Company long gone. The STC in question may have been purchased/acquired by Alan Peterson of Beryl D'shannon fame. In any case its not in production as he's into Barons or Bonanza's. Need more Power? Or is it a case of you have the power but need certification? See the posts on 180hp and Harry Dickler.

Thanks for the info. I called them and they do own the STC now but were unable to come up with the installation drawings. But he is going to look and see if he can find them. Its not a power issue rather than a paper issue. So i,m still looking for a copy of the drawings for that STC if anyone can help?

That somehow sounds familiar, I was remembering what my mom said to me sometime ago. Good luck