Page 1 of 1
Combination oil temp and press gauge
Posted: Fri Oct 17, 2008 7:53 pm
by Forrest Walton
When our plane was rebuilt, a combination oil temp and press gauge was installed. The temp part has failed. I am looking for a suitable replacement.
The face has US Gauge 19848 on it. It is a 31/8 " size.
Has anyone used one like this? Any ideas for the best source for replacement?
Thanks!
Forrest
Re: Combination oil temp and press gauge
Posted: Fri Oct 17, 2008 8:01 pm
by jrenwick
Forrest,
You could call Keystone Instruments, in Lock Haven, PA. They recondition all kinds of instruments, and also sell some original replacements.
http://www.keystoneinstruments.com/gauges.htm. Their reputation is excellent, and I have done business with them. (They rebuilt the combination gauge on my J3.)
Re: Combination oil temp and press gauge
Posted: Sat Oct 18, 2008 2:26 am
by GAHorn
Look anything like this?
Re: Combination oil temp and press gauge
Posted: Sat Oct 18, 2008 11:06 am
by Forrest Walton
Thanks George,
I looked on the Spruce site but was unable to find this. Thanks for your expertise!
Forrest
Re: Combination oil temp and press gauge
Posted: Sat Oct 18, 2008 5:20 pm
by GAHorn
Forrest Walton wrote:Thanks George,
I looked on the Spruce site but was unable to find this. Thanks for your expertise!
Forrest
You're welcome. But you might still call Keystone. They overhaul these probably cheaper than a new one would cost.