Page 1 of 1
master switch for 48 ragwing
Posted: Mon Jun 23, 2003 3:03 am
by russ murri
After all the testing, thanks George, I need to order a master switch. My illustrated parts book does not list them , I have the green covered illustrated parts book for just ragwings . I could not find it in Spruce. Where do I get one? The switch I am reffering to is the one behind the piano switch. I have a ragwing 170. serial #18419. Russ
Posted: Mon Jun 23, 2003 3:17 am
by mit
Look at Figure 32 Item 41 in the 1948 parts book, I believe that is your switch. P/N 8820K-5 Cutler Hammer.
Tim
Posted: Mon Jun 23, 2003 3:37 am
by russ murri
thanks Tim I looked right over it. now where do I go to get one? Russ
Posted: Mon Jun 23, 2003 3:50 am
by mit
russ murri wrote:thanks Tim I looked right over it. now where do I go to get one? Russ
One should be able to cross it to another Manufacture. Look thru the catalogs, AVIALL, Spruce...
George will probably know.
bad swich
Posted: Tue Jun 24, 2003 5:51 am
by russ murri
well I pulled out my master switch and bench tested it. It works about 1/3 of the time . Had to get one from Cessna not to bad about $32.00 Thanks for the help Russ
Posted: Tue Jun 24, 2003 6:24 am
by mit
Are they using the same P/N?
no
Posted: Wed Jun 25, 2003 4:43 am
by russ murri
No, they changed it to MS35059-21 Spanaflight in Puyallup Wa. said that Cessna had switches in stock, Iam looking for it on thursday this week. thanks again for the help Russ
Master switch '52 and older
Posted: Wed Jun 25, 2003 6:52 pm
by Collin Gyenes
Hi,
I bought a new master switch from Columbia Airmotive (503) 665-4896the cost was $7.95 I used the AN part number from switch to order.