I have Robert Schoerrs Padded Glare shield. C170 B 1954.
A/P needs access to run wire for lighted Hanging Compass. Issue is clearance between windscreen and end of glare shield.
I need tool advise.
I see two (2) Phillips screws holding the padded glare shield to top of original glare shield.
My question to the forum is how to remove screws?. There must be some special screw driver.
Not enough room for your hand holding a screw driver.
Remove Padded Glare Shield - Tool Advise
Moderators: GAHorn, Karl Towle, Bruce Fenstermacher
-
MoonlightVFR
- Posts: 624
- Joined: Sun Jan 02, 2005 5:55 pm
Remove Padded Glare Shield - Tool Advise
gradyb, '54 B N2890C
-
4583C
- Posts: 463
- Joined: Tue Apr 23, 2002 8:20 pm
Re: Remove Padded Glare Shield - Tool Advise
This???
You do not have the required permissions to view the files attached to this post.
-
cessna170bdriver
- Posts: 4114
- Joined: Mon Apr 22, 2002 5:13 pm
Re: Remove Padded Glare Shield - Tool Advise
A stubby Phillips fits mine with room to spare.
You do not have the required permissions to view the files attached to this post.
Miles
“I envy no man that knows more than myself, but pity them that know less.”
— Thomas Browne
“I envy no man that knows more than myself, but pity them that know less.”
— Thomas Browne
Cessna® is a registered trademark of Textron Aviation, Inc. The International Cessna® 170 Association is an independent owners/operators association dedicated to C170 aircraft and early O-300-powered C172s. We are not affiliated with Cessna® or Textron Aviation, Inc. in any way.