master switch for 48 ragwing

russ murri · Post by **russ murri** » Mon Jun 23, 2003 3:03 am

After all the testing, thanks George, I need to order a master switch. My illustrated parts book does not list them , I have the green covered illustrated parts book for just ragwings . I could not find it in Spruce. Where do I get one? The switch I am reffering to is the one behind the piano switch. I have a ragwing 170. serial #18419. Russ

mit · Post by **mit** » Mon Jun 23, 2003 3:17 am

Look at Figure 32 Item 41 in the 1948 parts book, I believe that is your switch. P/N 8820K-5 Cutler Hammer.
Tim

russ murri · Post by **russ murri** » Mon Jun 23, 2003 3:37 am

thanks Tim I looked right over it. now where do I go to get one? Russ

mit · Post by **mit** » Mon Jun 23, 2003 3:50 am

russ murri wrote:thanks Tim I looked right over it. now where do I go to get one? Russ

One should be able to cross it to another Manufacture. Look thru the catalogs, AVIALL, Spruce...

George will probably know.

russ murri · Post by **russ murri** » Tue Jun 24, 2003 5:51 am

well I pulled out my master switch and bench tested it. It works about 1/3 of the time . Had to get one from Cessna not to bad about $32.00 Thanks for the help Russ

mit · Post by **mit** » Tue Jun 24, 2003 6:24 am

Are they using the same P/N?

russ murri · Post by **russ murri** » Wed Jun 25, 2003 4:43 am

No, they changed it to MS35059-21 Spanaflight in Puyallup Wa. said that Cessna had switches in stock, Iam looking for it on thursday this week. thanks again for the help Russ

Collin Gyenes · Post by **Collin Gyenes** » Wed Jun 25, 2003 6:52 pm

Hi,

I bought a new master switch from Columbia Airmotive (503) 665-4896the cost was $7.95 I used the AN part number from switch to order.

The International Cessna^® 170 Association

master switch for 48 ragwing

master switch for 48 ragwing

bad swich

no

Master switch '52 and older