Continuing on the quest to positively identify my engine, can someone please answer the following...
Is the item circled in this picture what is considered the 5th/6th order damper on the crankshaft, which would identify it as coming from a -2H model (as opposed to the -2) since it also has the 8 hole flange?
... and no, I didn't pull a cylinder just for this purpose!
C-145 crankshaft damper
Moderators: GAHorn, Karl Towle, Bruce Fenstermacher
Re: C-145 crankshaft damper
Ohhhhhhh Boy, are you gonna wish you had spun a nut onto the carry through stud befor you snapped that picture! Lots of discussion here about the main bearings spinning when the crankshaft is turned while these through studs are loose which leads to this .
John E. Barrett
aka. Johneb
Sent from my "Cray Super Computer"
aka. Johneb
Sent from my "Cray Super Computer"
- Bruce Fenstermacher
- Posts: 10327
- Joined: Tue Apr 23, 2002 11:24 am
Re: C-145 crankshaft damper
That is the damper. The -2 can have a dampened crank or an undampened crank. The -2H will have a dampened crank assuming no one installed an undampened version since it came from the factory. The -2H engine should have the prop control on the left front pad as well.
CAUTION - My forum posts may be worth what you paid for them!
Bruce Fenstermacher, Past President, TIC170A
Email: brucefenster at gmail.com
Bruce Fenstermacher, Past President, TIC170A
Email: brucefenster at gmail.com
- cessna170bdriver
- Posts: 4068
- Joined: Mon Apr 22, 2002 5:13 pm
Re: C-145 crankshaft damper
In the C-145 series, those engines that originally came with a dampened crankshaft will have the letter D in the serial number (as opposed to the model number).
Miles
“I envy no man that knows more than myself, but pity them that know less.”
— Thomas Browne
“I envy no man that knows more than myself, but pity them that know less.”
— Thomas Browne
Re: C-145 crankshaft damper
All right then, it appears I have all the indications of a C-145-2H... I have the crank dampers, I have the provisions for the lever doo-hickey on the crankcase for a 2-position prop, I have a serial number with the letter "D".
The only hiccup is that my 8-hole hub flange also has the 1/4" drilled hole that I thought indicates a non-dampered crankshaft. Evidence in my case would contradict that notion. I'll post a picture of the 1/4" hole later.
The only hiccup is that my 8-hole hub flange also has the 1/4" drilled hole that I thought indicates a non-dampered crankshaft. Evidence in my case would contradict that notion. I'll post a picture of the 1/4" hole later.
1953 C170B - N170RP S/N 25865
Re: C-145 crankshaft damper
As promised, here's a picture of my 8-hole flange with the 1/4" hole clearly visible. Since I clearly have a damper-equipped crankshaft from the previous pic, it looks like the 1/4" hole = non-dampered crank idea is not 100% accurate. I thought this might be helpful for future reference.
-Kennet
-Kennet
1953 C170B - N170RP S/N 25865