Page 1 of 1
float kit install question
Posted: Mon Dec 01, 2014 8:36 pm
by learaviator
During the process of removing wings, carry through spars and cleaning up some corrosion, i found one od the rear carry through spar blocks with a drill bit sticking out of it. Apparently while drilling the holes through the block for the eyebolt, they misdrilled it and just left it. are their any known instructions for installing floats and drilling these blocks?
Re: float kit install question
Posted: Tue Dec 02, 2014 7:09 am
by n2582d
I've added
AK175-12P "Hoisting Provisions" to the Maintenance Library. It doesn't include the C-170 in the "Models Affected" list but does include the early model C-172. It should be "acceptable data" for a major alteration I would think.
Re: float kit install question
Posted: Tue Dec 02, 2014 4:46 pm
by learaviator
n2582d wrote:I've added
AK175-12P "Hoisting Provisions" to the Maintenance Library. It doesn't include the C-170 in the "Models Affected" list but does include the early model C-172. It should be "acceptable data" for a major alteration I would think.
Thank You for your reply!!! I missed that somehow!! Just what I needed!