The International Cessna^® 170 Association

Resource books still in storage, need info about rubber washers on both sides of firewall at motor mount through bolt.
Thanx,

John, one thing to be real careful about is there is a washer on the inside of the firewall that support the rubber --IT HAS A FLAT SIDE ON IT -- be sure that when replacing that you align the flat spot in the right place to keep from cutting the rivet on the support bracket. DON'T LEARN THE HARD WAY. I don't know how to answer your info question -What info? Ron

JMACFLY wrote:Resource books still in storage, need info about rubber washers on both sides of firewall at motor mount through bolt.
Thanx,

My IP book says the bushings are 0550155 (4 required)
The "pads" (smaller/rear bushings) are 0550154-2 (4 required)